![]() ![]() Audio Tab: 1) Sound card driver MME 2) Signal IO device - the microphone codec for the 7300 3) Audio IO device, your speakers 4) Channels: Left/Right = I/Q 5) Shift. Now in CWSkimmer settings: Radio tab: 1) Select SoftRock IF 2) set the audio IF to minus 12000 (-12000) 3) Set the sampling rate to 192kHz. 4) Select VFO B and set the mode to CW 5) Select VFO A and select FM. When I say loaned, I mean he picked it up at Ham Radio Outlet and brought it straight to me, so I could unbox it and shoot a series of videos, exploring the capabilities of this latest offering from Yaesu. My good friend Joel, KC4WZB, loaned me his brand new Yaesu FTdx10. Menu, Set, Connectors, ( of 4) ACC/USB Output Select: Set this for IF 2) Put your radio into FM mode. FTdx10 & IC-7300 Weak CW Signal RX Comparison. ![]() There are a few steps to do this: 1) set your radio to output IF instead of AF. ![]() ![]() An additional virtual audio cable software component needs to be added to the PC to route the sound between the web browser and the WSJT-X program. There are 2 main things that need to be done in addition to the normal remote control setup. But you can if you set your VFO B to use CW and then enable split! Thus you are able to decode CW with CW Skimmer and transmit. RemoteTx can be used to operate in the FT8 mode remotely after a few items are set up. This is the only mode that does not insert a band pass filter which sets the IF output to the audio frequency band pass of the mode in use. It can provide a 12kHz bandwidth in IF mode if you set your radio to FM. Solved! Hi, The IC-7300 has the ability to output both audio or IF signals over the built in USB codec. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |